MPCNC Dremel mount with source files

This is a Dremel mount I designed for the MPCNC lowrider 2. Can be adapted for other uses Source files included. This was made with the Dremel 4300 in mind so I am not sure if it will work with other Dremel tools.

I have spent countless hours designing this model and would highly appreciate if you left a tip.

Print Settings

Printer Brand:

Prusa

Printer: 

I3 MK3S

Rafts:

No

Supports: 

Yes

Resolution:

0.3

Infill: 

15
Filament:
Prusament Galaxy black, overture PETG , Blue 
 

Notes: 

This is a Dremel mount I designed for the MPCNC lowrider 2.
supports are only required for the "Dremel mount" file. make sure you uncheck "Don't support bridges" in your slicer. if you don't the slicer will not generate supports for the middle of the "Dremel mount" model. I have included screenshots of how the supports should generate.

I printed the models with 15% gyroid infill and 0.3mm layer height using Prusament and overture PETG.

you need to print 2 stopper pins. everything else you only need to print once.

fasteners:
4 m5 x 20mm.
2m6 x 50mm.
2 m6 x 30mm.
4 m5 nuts
4* m6 nuts
.

Post-Printing

assembly

The "AdapterPlate" is bolted to the flat part of the lowrider with four m5 x 20mm bolts with nuts on the bottom side. The "Dremel mount" slides onto the "AdapterPlate" and put the Stopper pin to freeze the mount in a set position. Fix clamp arm on the 3 finger mount on the "Dremel mount" and use the m6 x 30mm bolt and nuts to fix it. too clamp the arm around the Dremel use the m6 x 50mm bolt. It will cut its own thread in the model If not use a m6 nut. Be careful not to over tighten the bolt and tighten both bolts at the same time or you might snap the part.

Category: DIY