Starfield Desk Fan (motorized, fits on PRUSA MINI+)

This is my own functioning recreation of Desk Fan from Starfield Video Game by Bethesda.

NOTES:

• Hardware used:
  • Glue (either CA Glue or Hotgun glue is OK).
  • Motor C9058-60071 1060363 3K1962E5 uses M2x8mm screws- Couldn't find documentation for this (this piece is probably from inkjet printer like HP… maybe 24Volts? Works with 12Volts, but it's very weak)
  • Switch KCD1-1
  • DC-017 & 12Volt wall adapter
  • I suggest to connect 3D printed with toothpicks in screwholes and hotglue, but M3x20mm screws + M3 nuts can be used too.

• Some pieces require supports, but they are easy to remove
• Notes are added to printable pieces, if you want to print them in different colors.
• Added front grid piece (missing in photos)
• The black metallic tubing is actually a car trunk strut, BE CAREFUL WHEN YOU BEND IT! (added printable mini legs + leg bases in case you have bent strut :) )
• Find fan blades here (a bit of redesign in Prusa Slicer does the trick): Fan Blades

You can check the game-screen here on reddit (not my post!):

https://www.reddit.com/r/Starfield/comments/16as94d/who_brought_a_portable_fan_to_pluto_its_literally/

Expected print time of the kit with Prusa MINI+ is about 24 hours with 0.25 Layer Height and stock slicer configuration.

If you have any suggestions, let me know. I can do similar models if you provide screenshots.

Be creative :)