Bed Shims - Fits Creality K1 and K1 Max

great just fitted and running bed mesh prnited with ASA

thank you so much
very useful method

My bed went from 0.75mm slant to 0.3mm. Pretty happy!

Logre resultados excelentes aproximando de a poco los valores. Para la esquina trasera izquierda y derecha, como tienen el mismo apoyo, tenes que cortarlos a la mitad (foto 3) y poner distintas medidas de cada lado. Calibre con cama PEI a 60° con fluid complementando la calibracion con tornillos y la malla de 25 puntos. Pronto probaré con cama de vidrio a ver si puedo lograr un rango <0,04 entre maximo y minimo, eso seria un lujo.
Me fue muy util ya que suelo imprimir laminas grandes de 200x200 en 1 o 2 capas por lo que necesito que la nivelacion sea casi perfecta. Muchas gracias. (edited)

No conseguir solucionar la altura de capa pero ayudó a quitar 1mm de espesor.

Helped a lot, thank you for the quick and easy solution.

Worked as intended

Thanks for sharing, super easy to use!A larger print size option would help — my bed is seriously misaligned! :-)

very helpful shimes. my K1C bed is now complete ok

Works perfect for me! I started with over 2mm bed tilt, and don't even try "belt metod" from video. I must print two sets, make some try end error, some math and finally got decent effects.

When I set it I modify 1.0 spacer in slicer to get thicker ones to don't put two or three in sandwich.

Now I have 0.26 mm warp. Maybe it still a lot, but it's 10 times less than factory.

Easy to print and now 0.1 derivation

Worked beautifully, range went from 0.7531 to 0.4474 and finally 0.1697 as pictured.