Anycubic Kobra Go E3D V6 Adapter

I snapped the factory Kobra nozzle in the factory heater block so I decided I would just upgrade it with an E3D V6 I had on an old no longer functional printer, of course this demanded a mounting solution which I was unable to find pre-existing.

This mount is designed to work with the stock factory shroud, though it does require a shorter M3 bolt for the mount, longer M3 bolts for the shroud, and a set of M3 bolts and nuts to bolt the bracket to the mount that holds the V6 in place.

Since the diameter of the E3D V6 is larger then the stock hotend spacers are used to extend the shroud out 6mm, this is why longer M3 bolts are needed for the shroud mount.

The mount is designed so that the nozzle tip is roughly at the same position as factory, of course you will need to adjust your Z offsets to make it perfect (mine was within 0.4mm of the stock nozzle on my Z offset).

If you like my work and wish to support me then you can buy me a coffee!

Print Settings

Printer Brand:

ELEGOO

Printer: 

ELEGOO MARS 2 Pro

Rafts:

Yes

Supports: 

Yes

Resolution:

0.2mm

Infill: 

100%

Notes:

I printed my mount using my resin printer, of course there is no reason why you couldn't print this part on an FDM printer as well.

Category: 3D Printer Parts