Adjustable Light Mounting

Adjustable mounting for some shop lights for a garage or workshop,

I made these from PLA+ 20% infill on an Ankermake M5C , printed without supports. The design uses a 4mm countersunk screw and an 4mm cap screw for the pivot and clamp. I used 4mm jam nuts to hold it all together.  I used the provided lighting clips and short 3mm screws to attach it to the printed part (not shown) but really anything can be used for that. The lights I used were from Amazon Ensenior 6000k 5000LM  4 foot lights. Use the provided assembly to modify as needed and to see a mcmaster-carr pn for the screws and nuts.