Rasberry Pi 4 Water cooling Case

I made this for a project, and I'm really happy with how it turned out. I am not an experienced CAD designer, but I thought that someone might like this design as much as I do! It uses an 80mm radiator and fan, with a cheap water cooling pump from Amazon. I'll link everything down below. I printed everything in PLA, except for the TPU feet. I used an L298N motor controller for the pump and fan. I am aware they are PWM, but I don't know how to program it, nor do I want the extra wires going to the Pi. Some parts use M2.5 screws, like the Pi mounts and the case joins, but I think the rest is M3. I did not make the Pi logo on the case. 

Here are most of the parts I used:

https://www.amazon.com/dp/B07PS8V4V3?psc=1&ref=ppx_yo2ov_dt_b_product_details

https://www.amazon.com/dp/B07PB19PLC?psc=1&ref=ppx_yo2ov_dt_b_product_details

https://www.amazon.com/dp/B094R3QTYM?psc=1&ref=ppx_yo2ov_dt_b_product_details

https://www.amazon.com/dp/B0BNZVDK1X?ref=ppx_yo2ov_dt_b_product_details&th=1

https://www.amazon.com/dp/B09YTW747X?ref=ppx_yo2ov_dt_b_product_details&th=1

https://www.amazon.com/dp/B0BDWV1BCV?ref=ppx_yo2ov_dt_b_product_details&th=1

https://www.amazon.com/dp/B07TYQRXTK?psc=1&ref=ppx_yo2ov_dt_b_product_details

https://www.amazon.com/dp/B08C2PVP7J?ref=ppx_yo2ov_dt_b_product_details&th=1

https://www.amazon.com/dp/B07SLYLMYS?psc=1&ref=ppx_yo2ov_dt_b_product_details

https://www.amazon.com/dp/B08PTWQCRP?psc=1&ref=ppx_yo2ov_dt_b_product_details

https://www.amazon.com/dp/B0852HX9HV?psc=1&ref=ppx_yo2ov_dt_b_product_details

Feedback is welcome!