ESP-01 electronics box

A nice electronics box for the ESP-01 wifi module with 5v-3.3v adapter. Original design can be found here: https://www.thingiverse.com/thing:3472764

Assembly:

• The box is snap fit, not too tight, but depends if you have calibrated your e-steps :)
• 2 or 4 M2x8 screws are required to hold the board in place (they are thread in nice and snug)
• On the side holes M3 screws can be used in the required length to attach the box to the frame. The head of the screw should be inside the box, and can be turned from the opposite hole with an allen key or small screwdriver