Spare nose bridge and side pieces for safety glasses

After a while of use, the rubber pieces on my corrected saftey goggles started to ooze out the plasticizer, got squishy and started to disintegrate. Therefore I decided to replace them. The model is a uvex RX cd 5514, size: 55/18.

The side pieces were printed in TPU (82A) without any supports. The rubber side pieces fit quite tightly onto the thin metal frame, so they stay in place perfectly. One piece was printed with the given orientation in the stl file, the second piece was mirrored in PrusaSlicer. This is not strictly necessary, you can also print the same piece twice without mirroring.

The nose bridge was printed in the orientation from the stl file in PETG with full supports. It was then attached to the glasses with the screws from the original part.