ERCF EasyBrd/Burrow Board Ceiling Bracket Mount

This is a mount for the EasyBrd/Burrow to be used with my ERCF Ceiling Mount 

BOM

• 4x M2 heat-set inserts
• 3x M3 heat-set inserts
• 4x M2x12 screws
• 3x M3x6-8 screws

Instructions

1. Install 3 M3 inserts into the board mount. 
2. Install 4 M4 inserts into the back of the board mount
3. Mount your ERCF board to the bracket.
4. Use the 2 braces to secure the board onto 1 of the 4 pillars using M2 screws - Make sure your usb and power cables fit at the mount point!

Happy printing!