No scaling needed , first was a tight fit , but two or three turns later good fit.Thank you very much. Good model.
Solid Woodworking Marking Gauge
The Tool was printed with a Prusa mini +
You will need a 40mm socket head bolt and an hex nut.
2,740
5885
41
20 k
updated May 25, 2021
Makes
Comments
Great tool!
I used advise from another makes and printed screw at 98% it worked well.
Excellent tool for marking straight lines. Made a knob for the M5 bolt securing the pencil. This removes the need for keeping a suitable Allen key / bit close by.
Printed with no problems and all parts were a good fit with no modifications needed. Thank you for sharing this design. Printed on Prusa Mk3s Esun PLA+
Prints fine. Screw needed no scaling, just a little force on the first fit to smoothen out some rough edges from printing.Only minor point is that I would have loved, if the width of the large body would have been either larger or smaller, to fit a 40mm or 30 mm screw without showing through. But that is purely cosmetical.
