OneWheel Pint/XR Extended Stand

OneWheel vertical stand with extended depth for use with aftermarket, angled rails. Will fit Pint/XR TFL WTF rails.
11
95
1
377
updated May 23, 2024

Description

PDF

OneWheel vertical stand with extended depth for use with aftermarket, angled rails. Tested and will fit Pint or XR with TFL WTF rails. While theoretically it may work with stock straight rails, it'd lean much farther back than it would on the original model.

Printing Instructions

Print in your preferred material with as much infill as you like, but here are some print settings recommendations:

  • 10% or higher infill should be plenty strong.
  • Supports disabled!

Once configured:

  1. Print the model on its side, with no supports.
  2. Take it off your print bed when it's done. Boom.

Tags



Model origin

The author remixed this model.

Differences of the remix compared to the original

Extended the depth of the resting plate from 60mm to 80mm, to accommodate angled rails. Also reinforced the front plate with 2mm more thickness to support the added force from the additional lean of the board.

License