Bondtech gears idler backport for mk2.4

I previously printed MK2.4 extruder mod, now I want my bondtech gears back.

This is a retrofit of bondtech gears to MK2.4.

Parts:

• Bondtech idler
• 20mm idler rod
• 2x bondtech idler bearings
• M3 locknut (regular M3 nut would work too)

Assembly instructions:

See photos for assembly instructions. I used drill to work in bearing holding rod, then vice grips to slide the rod into rod holders. You can also work if you align bearing rod against thicker rod holder and then press the rod against any hard surface, this will press fit the rod into place.

I mashed together the original MK3 idler mount for bondtech gears and MK2.4 mod idler to fit bondech gears to mk2.4