15 Minute Wham-Bam Thank You Ma'am Flat-pack iPhone Stand Landscape

This is an iPhone stand designed to print flat on the build plate in multiple pieces that snap together. Goals were to print fast, use a minimum amount of filament, and to pack into a very small space. Although tested with iPhones, this will likely work well with other phones.

This has been printed with PLA but would also work well with PETG. The files included are sized for a typical phone, but could be scaled up for use with a tablet.

Printed at 0.3mm, this will complete in 15 minutes on an Prusa MK3.

This was designed to hold the phone in landscape orientation. I have a design that will work for portrait and landscape mode. It is a bit larger and prints in 26 minutes.