Sony PVM Rubber Isolation Foot

Description:

A direct replacement for the Sony PVM-14L5 rubber isolation feet. This will also fit other PVMs such as the 20M4U and 1954Q.

Printing:

• Foot: Use FlashForge ASA or equivalent alternate.
  • 0.4mm Nozzle, 0.2mm height, 50%+ infill, 3+ walls.
  • Alternate materials such as PC, PETG or PLA would work too.
• Insert: Use PolyMaker PolyFlex TPU or equivalent alternate.
  • 0.4mm Nozzle, 0.2mm height, other settings are not very important.

Assembly:

• Insert rubber into the foot, it should be a snug fit but optionally glue can be used to ensure it does not fall out.
• Use an M4x14mm through 18mm screw to install.

Note: Amazon links are affiliates.