Pocket toothpick holder

I needed a way to take along a few toothpicks in my pocket. The cases provided with the toothpicks are either too large or accidentally open in your pocket, leaving you with a pocket full off loose thoothpicks.

So therefor a simple design to fullfill my requirements, maybe it's of use to you too.

The tolerance between the inner and outer part is small, this is intentional to prevent accidental opening. And after some use, the parts wear a little and the sliding is smooth. But make sure you've got your settings dialed in. Suggested print orientation is found in the pictures.

There are 3 versions in length:

Original 55mm version
It holds about 18 toothpick and is designed for a toothpick length of 5 [cm]. Outer dimensions of the box are approx. 1 x 2 x 5.5 [cm].
Tooth pick case - inner.stl
Tooth pick case - outer.stl

65 mm version
Increased inner length to 6.5 [cm]
Tooth pick case - inner 65 mm.stl
Tooth pick case - outer 65 mm.stl

70 mm version (130% scale)
Increased inner length to 7.0 [cm]. This equals to the 130% as mentioned in the comments.
Tooth pick case - inner 70 mm.stl
Tooth pick case - outer 70 mm.stl

I would suggest printing it in PETG.