Days Since Last Print Failed Tracker

Based on the "XX days since [insert bad event]" signs that tend to pop up in TV and movies, I made a days since last print fail tracker.

The sign itself just prints flat on the bed then slots into the base which also provides space to store other number cards when not in use.

There are 2 spaces for hanging numbers - I was going to do 3 but the idea that any of us would make it into triple figures seemed a little optimistic! The numbers are just held in place with the printable pegs.

The text is raised in 1mm increments so you can pause and change filament manually (as I did) for the different colours or you can print in one colour and easily run over the surface with a marker if you prefer - or just leave it one colour for that matter!

Any material should be fine (I used Prusament PETG) -

No supports needed, everything prints flat on the bed.

Text is raised to different heights so you can achieve the multi-colour effect without a multi material printer, just pause and change filament manually (this can be set up in most slicers or done on the printer itself).

The pegs are quite small so you may need a raft or brim though I managed to print them okay without.