LED Spiral Christmas Tree - Remix

**Shout out to JamesThePrinter for the original file (614179-christmas-tree-set) Please checkout his page.

I hollowed out the bottom of the tree for an LED and the Tall Trunk to fit a micro USB module.  You can use a 220 to 250 Omh resistor to lower the voltage or please use a chart for the correct value.

Printed in Marble PETG @ .20 layer height. 

Ender 3 S1 Plus
Sonic Pad - Running Klipper (Fluidd)
.04 Nozzle
.20 Layer Height
PETG - Marble

Spiral Tree Settings: Infill: 20% - Concentric.  Better transfer of light, it will hollow the sides. No supports.
Tree Trunk Settings: Full sides, I used supports.

Thank you for the original files, Big Time James!!!

I hollowed out the bottom of the tree for an LED and the Tall Trunk to fit a micro USB module.  You can use a 220 to 250 Omh resistor to lower the voltage or please use a chart for the correct value.  It shines a cool green spiral light in the ceiling.