nice print
4x6 inch Picture Frames
You know that classic picture frame, kinda looks like crown molding. Now you can print it.
55
311
2
1178
updated December 11, 2023
Makes
Comments
When i put the file into my slicer it shows the bottom of the frame with a tab on the bottom, so frame will not sit flat on the build surface. Also the center looks to be part of the frame. Not understanding here
Nozzle: 0.4mm
Layer height: 0.16mm
Filament: Hatchbox PLA Wood, MatterHackers Build PETG Black
Supports were a bit of a pain to remove, and the holding clips are a bit tight to turn but came out well.
@marbledradial_630230 I'm glad it worked for you! I think I was using a .17 interface for supports, they were tough to start occasionally, but once they started they went easy for me.