Hexagon Benchy Display

This is a modular hexagon display system for test printing benchy models that can be displayed. If you squint a little, you can also use these models as a way to verify your print tolerances.

The stand base can be used on the bottom-most hex pieces as a more stable place to stand the display up on a desk or shelf.

Similar to the original design, I've included a nail guide with the tighter gap to assist with placing nails for wall hanging of the hexagons.

UPDATE - 11/7:
I've added a new file for a nameplate that can fit in the top section of the hexagon hoop, similar to my V2 remix.

The original design fit a bit looser than I wanted, so I tightened the gaps for the T slots. I also lengthened the shelf a bit and added a small divet for the benchy to be placed into. Lastly, I've included a model for a base plate so that the setup can be displayed on a shelf or table top.

Enjoy!