Meta Quest 3 Controller Wall Mount (Deluxe Color Version)

I needed a wall mount for the Meta Quest 3 controllers. I designed this one, a „deluxe version“, with some unnecessary decorations. 

It’s a game controller, isn’t it? - So it should look like one, too.

I made another,  simpler version without the decorations (link), smaller footprint and less filament usage, too. I will publish the link here shortly.

Everything is printed in mono color PETG. The colored parts snap into their referring slots in the body. Only the front logo and letters may require a little bit of sanding. If they do not sit tight enough a little drop of glue will do the job. 
 

The body is printed in PETG with 0,4 nozzle and 4 perimeters min. It can be printed without supports. I enabled some small supports to be safe. 
 

The decorations were printed in different colors with 0,25 nozzle and 0,15 layer height for better detail . For the logos and letters enabeling ironing makes the surface look much better. They don’t need supports. nevertheless i added very little supports for some parts to be on the safer side. 
 

Please show me your results and send me fotos of your makes. I like to see how you use this model. If you have ideas for improvement don’t hesitate to send them to me in the comments.   I will try to incorporate your suggestions and will modify the model for special needs if you ask me to do so. 
And of course a like ♥ or a rating ⭐ of the design are always welcome. 

happy printing, clamikra