1 Channel Relay Module Mount Snug & Snap fit versions

!!!*(Ver8 is Snap Fit Ver7 slightly loose but can work)*!!!

This is for a Relay Module with dimensions: L 43.78mm x W 26.28mm

Stand-Off's are hole ready! (No drilling Necessary!!!)

Snug Fit and flush mount

I also made this so that it can fit ~ 6mm Length screws. (board mount)

Lightweight & Strong Base Support!

This is my First Project since my Printer has been "Dialed In"!!!

(Detailed Prints without hairs and flat,aligned,clean)

As long as the bed is level EVERY TIME!

I used Fusion 360 to design this project. Then my slicing software is slic3r currently. I keep my settings low. Then you get a strong durable part!

I hope you guys enjoy and use this!

On Adafruit Show & Tell January 27/2016 https://www.youtube.com/watch?v=03kcbBZcsLg

2 Channel Relay Mount: http://www.thingiverse.com/thing:1285305

4 Channel Relay Mount: http://www.thingiverse.com/thing:1287530

8 Channel Relay Mount: https://www.thingiverse.com/thing:4992420

Print Settings

Printer Brand:

RepRap

Printer:

Rafts:

No

Supports:

Infill:

80%

Notes: