XBOX One/Series Controller and Headset Wall Mount

Remixed from LUN5H TIME's original Xbox 1 Controller / Headphone Wall Mount V2

I redesigned this model using the original design side profile as it works great for holding the XBOX Controller. However, the controller can move left and right and I was planning on mounting this in an RV and didn't want the play, so I made the mount wider to remove any side to side movement. I also kept it simple so it can print on its side which results in no supports needed and a stronger print.

Print Recommendations

• No Supports Needed (prints on side)
• .20mm Layer Height
• 15-20% Infill
• 4 Vertical Shells/Perimeters (for added strength)
• Rotate model to print on its side (see photo)

Holes are designed for ¼-20 counter sunk bolts.

I took the side profile and made it wider so the controller wouldn't shake or slide as I am planning on mounting this in a van and wanted less slop. I also made it so it prints on its side without supports which also gives it a stronger support. LUN5H TIME's original model works great and would recommend if you are using in a house where things are more stationary :)