Artis3D feeder Type MK (for Creality K1/K1MAX) OUTDATED!

This is a feeder for Creality K1/K1MAX which is based on BMG extruder gear set. This feeder in lighter than original K1's and has adjustable rocker tension.
There are 4 variants:
* MK - for 10-teeth NEMA14 motors
* MKe - same as MK but a bit higher and has a hole for motor mounting screw (can remove motor without feeder disassembly)
* MKem - similar to MKe but for 12-teeth NEMA14 motor (original for K1).
* MKemu - same as previous one but has unclencher which lets easily change filament
Pay attention that for MK and MKe it is necessary to cut shaft to 2.5mm from gear side (it lets to use 10t NEMA14).
Recommended filament: PETG, PA (fiber), ABS/PC, PBT
Recommended printing parameters: 0.4mm nozzle diameter, 0.1mm layer thickness, 40mm/s printing speed, printing without supports excluding tensioner fixing eye and tensioner bracket (look at 07.png).
Links to extruder parts:
BMG gears set:
https://bit.ly/47oLQib
https://bit.ly/3uabEA0
https://bit.ly/49qzdVt
BMG Extruder (clone):
https://bit.ly/3tXF8ky