Bambu Labs (P1S) SD Card Bezel
The original file was for a P1P. I have a P1S and the glass cover would not close using the original.
4
49
0
768
updated December 3, 2023
Description
PDF- I used standard PLA settings for Overture PLA with tree supports. I oriented the print with the front facing downward and used tree supports everywhere, not just the build plate.
- I changed the factory micro SD card to the 32 GB high endurance card https://www.amazon.com/dp/B07P14QHB7
- I also used this SD extension as did the original author https://www.amazon.com/dp/B078YPFJ4J
Model origin
The author remixed this model.
Differences of the remix compared to the original
This remix is for a Bambu Labs P1S. It will allow the glass lid to open and close normally while still providing the use of the original micro SD to SD card adapter as shown in the original Make. As shown below, the factory display is recessed and the bezel is raised. This was done to allow everything to fit and have clearance with the P1S micro SD card slot.
Here is a side view with the glass lid closed. I printed this using Matte PLA with no installation issues.
