Tripod Head - Hama Star 61

The tripod head was broken lengthwise. For the repair, I only replaced the head (in yellow). The rest of the parts could be reused. The tripod head is connected to the rest of the tripod by a 40 mm M6 screw. The screw was glued into the plastic and had to be broken out. The bubble level was also glued in place and had to be broken out as well.
 

Print

For a good printing result, I recommend printing some supports around the hinge.

Post-Processing

The clamp lock is fixed with a screw. The hole of this screw must be broken manually after printing. I only printed one layer, which can be broken through with a bit of force using a pointy object (i.e., screwdriver).