QuickStick mount for Adafruit modules - Din Rail

An Din Rail mount for up to five Adafruit Qwiic modules using M2.5 screws. This is for a more permanent usage.

This design can mount up to five modules. The double set of screw holes in the last position allows for hanging a module off the end so that through hole components do not interfere with the board mounting.

There are two versions of the mount. The first is for modules that are flat. The version with the wells is for modules that have had a header soldered in.

You will need to print one tabs for this design.

They can be found at: https://www.thingiverse.com/thing:3401942 or
https://www.prusaprinters.org/prints/8512-din-rail-mounting-tab

Print Settings

Printer Brand:

Prusa

Printer: 

I3 MK3S

Rafts:

No

Supports: 

No

Resolution:

200

Infill: 

20

Filament:
inland PLA

Category: Electronics