Dual 5015 blower duct for Ender 3 V3 SE

Yes, A remix of a remix.

TL;DR stock hotend printers use:

• Duct_Left_Stock.stl
• Duct_Right_Stock.stl

⠀

I really liked the shroud and my V3 SE was lacking in the cooling department. so after 4 test prints and a bunch of measuring I present the Dual 5015 blower for the V3 SE.

Please forgive my poor modeling skills I use sketchup so it's not perfect but it's functional-ish.

I used extra X axis motor screws from a kit, the left side you can use a larger diameter screw and tap threads into the plastic for the fan if you don't have a nut compatible with the motor screws. For the right side the extruder screw is roughly 5mm too long I used a plastic washer you can always use the right size screw too I didn't have one, the hole is shared by the fan and the bracket for mounting.

This is a significant redesign as far as mounting goes.
The ducts are still the same as the original.