Karten-Eiskratzer (Card Ice Scraper)

Der Karten-Eiskratzer ist vielleicht der letzte Eiskratzer den du für dein Auto benötigst!
In the contest Defrosting Cars
5
25
0
237
updated December 2, 2023

Description

PDF

Der Karten-Eiskratzer ist vielleicht der letzte Eiskratzer den du für dein Auto benötigst!
Einfach eine der vielen abgelaufenen (Debit-)Karten oder Werbe-Plastikkarten reinschieben und loskratzen.
Ist die "Klinge" abgenutzt kann sie auch nochmal gedreht werden.
Aktuelle Karten würde ich nicht verwenden, da sie dabei schon "verschleissen" und Kreditkarten sind wegen der Prägung zu dick.

Beim Drucken würde ich ABS/ASA oder PETG oder PA (Nylon) empfehlen. PLA tuts schon auch, dann würde ich den Eiskratzer aber im Sommer nicht im heissen Auto belassen.

Meine Druckparameter:
Drucker: Bambu Lab P1S mit Smooth PMI Plate
Material: ABS
Brim: 6mm (Warpinggefahr wegen der Höhe vom 90mm)
"langsam" drucken, besonders die erste Schicht und Objekt-Lüfter erst ab der 50. Schicht: 10%
Ich habe die Smooth PMI Plate verwendet, die Textured PEI sollte aber auch klappen
0.2 mm mit 3 Wall-Loops und Top/Bottom: 4 Schichten
Infill: 55% Tri-Hexagon
Mit Support (nur Build Plate) und senkrecht drucken

(Ich lade meine Projektdatei mit hoch)

-------------------------------

The Card Ice Scraper may be the last ice scraper you need for your car!
Simply insert one of the many expired (debit) cards or promotional plastic cards and scratch the ice away.
If the “blade” is finished, it can be turned again.
I wouldn't use current cards because they would "wear out" and credit cards are too thick because of the embossing.

When printing I would recommend ABS/ASA or PETG or PA (nylon). PLA works too, but then I wouldn't leave the ice scraper in a hot car in the summer.

My printing parameters:
Printer: Bambu Lab P1S with Smooth PMI Plate
Material: ABS
Brim: 6mm (risk of warping due to the height of 90mm)
Print “slowly”, especially the first layer and object fans only from the 50th layer: 10%
I used the Smooth PMI Plate, but the Textured PEI should also work
0.2 mm with 3 wall loops and top/bottom: 4 layers
Infill: 55% Tri-Hexagon
With support (build plate only) and print vertically

(I upload my project file)

 

Tags



Model origin

The author marked this model as their own original creation.

License