This is a side mount for the Creality laser kit.
It consists of two parts:
- Control Box Mount
- Power Adapter Mount
This is designed with the following key points in mind:
- print with minimal support
- rails are not to tight, for easier installing (and deinstalling) on the printer
- integrated cable management
- power supply is located at the rear, for easy switching of the power cable between printer and laser kit
Tip
This print may require more ground clearance than the original feet provide.
I use these Squash Ball Feet (V2 raised): https://www.printables.com/de/model/152248-ender-3-v2-squash-ball-feet
Control Box Mount
The bottom right screw hole is a slot, as in my control box the scew was not placed with the same spacing as the other three screws.
- Print lying flat - support for rails needed

- Unscrew backside of control box

- Insert cable clip

- Screw mount to backside of control box

- Fasten cable clip

- Watch out, that no part is looking over the bottomside, otherwise you can not slide it onto the printer

Power Adapter Mount
- Print standing up - no support

- put the long small cable of the power adapter into the smaller hole (just for cable management, that the cable is stowed away)
- put the cable of the control box through the bigger hole
- place the adapter in the mount and fixate it with a cable clip

Tags
The author marked this model as their own original creation.