Elgato Wave 3 Horizontal Low Profile Stand

Tuck your Elgato Wave 3 under your monitor without blocking your view! Reduces height by half. Uses stock hardware.
8
59
1
461
updated December 1, 2023

Description

PDF

This is a mic stand adapter that enables you to mount your Elgato Wave 3 horizontally. This is especially useful for those who keep their mic under their monitor or in other places where a lower-profile mic is desired.

Hole on top for DIY expandability (be sure to link your models as a remix!):

  • Camera stand
  • Flat surface
  • Gridfinity baseplate
  • Ring light
  • Second mic
  • Decorative print (a cat or a nice finial)
  • Handle
  • Macro pad

Print:

  • Print with the “back” down as pictured. No supports needed. Brim optional.
  • Tolerances are fairly tight, but just right for a BambuLab X1.
  • It's okay if the top of the circular indentation sags a bit, this is by design (the mic has a flat spot at the mating location)

Use:

  1. Remove the original bracket from the stand and the mic
  2. Install the new bracket to the mic using the original thumb screws
  3. Push the new bracket onto the post of the original base
  4. Screw the new bracket it into the ¼-20 stud at the top of the base's post
    1. You may need to push the bracket in while turning
    2. If you put the knob on the right side then the LED's indicate value from the bottom (min) to the top (max)

Tags



Model origin

The author marked this model as their own original creation.

License