Parametric Threaded Cable Grommet for the E27 fitting

Threaded Cable Grommet for the E27 fitting

Appropriate for round or flat flexible cables, configured by default for European E27 fittings with a M10x1 thread.
The default stl exports will fit a generic flat 2x0.75 mm2 cable.
You can customize the model in OpenSCAD Customizer if you have different requirements.

Printing guidelines

• Setup OpenSCAD (if you would like to adjust the model)
  • Install the threadlib library
  • Optionally modify the project in the OpenSCAD Customizer
  • Export the stl file
• No supports are needed
• Print in PETG with a 100% rectilinear infill using the 0.05 mm or 0.07 mm ULTRADETAIL settings
• Use the "Avoid crossing perimeters" setting in the PrusaSlicer (so you can make sure the cable grommet does not get obstructed).