Fiberlogy spool insert

Insert for the new Fiberlogy spool. The insert is used to reuse an empty fiberlogy spool multiple times.

 After making this modification, you can put Refill filament on the spool.
The used spool should be disassembled. Place a 2mm spacer ring on the spool plate. Then glue the paper roll on top. Glue the cap to the center of the paper tube and plate. Remove the studs from the second plate so that the plate can rotate freely in the paper tube. The screw should be glued to the second spool plate (I use two-component epoxy glue). Ready.

Printing recommendations:
If you are going to use a spool in a drybox, think about a temperature-resistant material.
Layer height 0.2mm,
Number of outlines: 4,
15% fill

I'm adding the second version. This version combines Spacer and Paper Tube into one piece. The Spool nut-v2 should be glued to the first disc. Glue the Spool screw to the secend plate.