make it level - drill helper

This thingy helps you making leveled bore holes in the wall for shelf's, pictures and other stuff that need at least to holes in the wall. 

additionally you need a 3mm x 10-15mm screw countersunk wood screw per clamp.

print instructions

• print at least 2 complete clamps
• I recommend PETg, others will probably do
• 3 perimeters (or more)
• I used 0.6 mm line width to strengthen the wall
• a bit of infill, I used 15%

assembly

• put the countersunk wood screw in
• if wanted glue the screw cover in the hole where the wood screw is
• put the printed screw in
• do this for each clamp
• put clamps on the level

usage

• put clamps on your level
• set distance of the clamps to needed size. 
• hold it on the wall and make it level
• press gently on each clamp to mark the holes
• if necessary use a pencil to highlight the marks, so you will find them later again
• on the marks: drill a hole or put a nail in, whatever you need

See also my other workshop stuff: https://www.printables.com/@Antimaterie/collections/1000059

Additional notes

I'm interested in your feedback to improve my stuff! So give me likes, post makes, comment and rate the print to show others and me how well it goes.
If you post a make, let me know which filament you use.

If you want to support me by donating a coffee go to https://ko-fi.com/antimaterie I would really happy about it. The money will be invested in all stuff regarding 3d printing to give more and better quality models.

In general my Prints are not for commercial use, but if you are a print farm owner and want to sell some of my stuff, please contact me.

Hope you enjoy my models.