Virpil CM3 detent for CosmoSim/SWS
Description
PDFThis is a detent for the Virpil VPC MongoosT-50CM3 Throttle made for Star Wars Squadrons (SWS). In Squadrons you spend a lot of time going from full throttle to zero throttle (and a few times in the middle) very rapidly and almost constantly. This throttle has a LONG rang of motion that while brilliant for precision flying, makes for a lot of rowing in SWS. This detent reduces the arc of travel to~40 degrees and includes a center notch for that maneuverability sweat spot.
Two versions provided here. Both with more or less the same geometry, but one has an over hang that captures the detent roller from lifting. Due to the geometry of the detent lifters if you push too hard you can overdrive the detent. The one with overhang prevents that.
Notice: be sure to update your throttle's calibration range with the detent installed in the Virpil software. Otherwise you will never be able to get to 0% or 100% throttle.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3 Pro
Rafts:
No
Supports:
Yes
Resolution:
.200
Infill:
20% gyroid
Filament: eSun PETG Black
Notes:
Prints best on it side with supports from the bed only. Can be printed without supports but the alignment notch may not be clean enough for a nice clean fit.
Tags
Model origin
The author marked this model as their own original creation. Imported from Thingiverse.