I have 3 request please. 1. Make the fillet's on the vertical corner's of the bottom part of the feet a little bigger, say about 3-5mm. 2. Make a version of the feet where the top section is only 1/2 inch tall. 3. Make a version of the whole set of brackets for 2x3 lumber. I want to make a printer stand for two printers stacked on top of each other. Kind of like a lack table setup. Thanks!
Shelving Unit 3d Printed Brackets
All Things STL Shelving Unit, can be made in any size, and hold 1000 pounds!!
This is an exclusive model available only to supporters of the creator.
Your funds support the creator's further activity.
86
0
6344
updated October 9, 2024
Makes
Comments
@jonbourg I will get on that now! Thanks for being a club member
@Allthingstl Thanks!
The model looks great. I am planning to build one 6 or 8 feet wide. Do you have a bracket that can be place in the middle of the width for additional support? I am thinking of putting an addition support 2x4 around 3 or 4 feet of the width.
@xfyy55a1_1900519 let me know what you are thinking and I’ll make one for you.