Creality K1 D3vil Burner Knomi V2

The Latest D3vil Burner for Knomi V2 !! 

Introduction  

D3vil Design Burner for Knomi V2 , this model is made with lower colling ducts ( i will try to update it with a higher version later.

Features 
- Drop in replacement for the Creality K1 and Max- some cut needed for the Part fan blower
- Knomi V2 touch screen - view print progress real time, and add a little flair to your toolhead!
- Customizable LED featuring the D3vil Design logo - use any LED to match the style of your setup!

• Direct access to the USB .. no need to remove the toolhead everytime you wish to reach the USB port.
   

 Very Important 

You have to cut around 3-5mm of the plastic of the blower fan where the screws are ( check the image ) This is because there Knomi V2 is thicker and pushes the Blower backwards .. and the blower fac could make contact with the Toolhead board and short-circute it …. you dont want to see the magic smoke leavs ur K1. please be carful .

**Instructions and Support**

Best way is to print it would be with support and the cover facing upward. but it will use alot of support. you can print it face down but the finish depends on how good your printer with overhangs.

For install instructions, check out or Github page ( this is for V1 .. which is around the same )

For support, join our Discord. if you need any help or support.

Where to Buy Knomi here BIQU 

We do this for fun and for the community, we are self funding all the projects and we do not want money as much as we need your help, knowledge and support.