Unifi Protect G3 Instant - 25 degree angled stand

One of my Unifi Protect G3 Instant camera is standing on a high cabine but needed a bit of a down angle (25 degrees) to get a better picture of the whole room.

Unfortunately, the default camera can only stand straight up, or needs to be wall mounted if you want adjusted angles. 

So I designed a basic stand that fits the camera nicely in a 25 degree angle and has a slot for the camera cable. The latter also functions an additional hold for the camera so it does not accidently tip over.

Print instructions:

Material: PLA should be fine or PETG if in a high UV spot
Layer height: 0.2 mm
Supports: No
Infill: 10-15% is enough