Is it possible to integrate beacon sensor to this setup?
Lightweight toolhead for Ratrig V-Core 3.1 with Goliath Short, VZ-Hextrudort and CPAP (MGN9H)
Lightweight, yet rigid and simple toolhead for Ratrig V-Core 3.1 with Goliath Short, VZ-Hextrudort, CPAP and MGN9H rail.
12
55
0
1725
updated November 29, 2023
Makes
Comments
@Auggie_53804 Not sure, I don't own one. I think it is mounted with two screws? Maybe you can add two holes to the underside of the back-bottom part inside the slicer and mount it there?
I’m back with another question after buying a used ratrig. Will this printhead work with a stock vcore 3 rather than a 3.1? I’m thinking the belt paths might be misaligned
@JamieClarke_466858 Sorry don't know, never had a 3.0.
Does the heatbreak have to be modified for using this design or does it use the water cooling heatbreak? It seems like it would need to be very short compared to the aircooled heat break
View 4 more comments
@Auggie_53804 There is a fan, but on top, and no dedicated coldend heatsink. Ambient temp here is around 22C.
@EnderEnder_486751 Do you know if the extruder fan mount can work when the vzbot is in the stock orientation, i.e. facing straight forwards?