BIFRC spot welder snap fit case

This is a snapfit case for the BIFRC spot welder. No mouting screws are required. The case is a tight fit, without visible gap between the case and the lid.

I used a bit of hotglue to cover the hole for the LED. The light from the LED will lightup through the semi transparant hotglue (if you don't use to much ;) )

The pcb doesn't rattle inside the case and is kept tighly in its position.

Print Settings

Printer Brand:

Ultimaker

Printer:

Ultimaker 2

Rafts:

No

Supports:

Yes

Resolution:

0.1

Infill:

25%

Filament: Colorfabb PLA black and red

Notes:

I used Cura for slicing. Printed with tree support, 0.1mm layer and 25% infill.