BIFRC spot welder snap fit case

This is a snapfit case for the BIFRC spot welder. No mouting screws are required. The case is a tight fit, without visible gap between the case and the lid. There is a button and a hole for the LED.

I used a bit of hotglue to cover the hole for the LED so the light from the LED will lightup through the semi transparant hotglue (if you don't use to much ;) )

The pcb doesn't rattle inside the case as it is kept tighly in its position.

Print Settings

Printer Brand:

Ultimaker

Printer:

Ultimaker 2

Rafts:

No

Supports:

Yes

Resolution:

0.1

Infill:

25%

Filament: Colorfabb PLA Black & Red

Notes:

I used Cura to slice the model and used tree support as it is easier to remove than the traditional support and also uses less material