BLTouch Mount for Bondtech Prusa Extruder

Longer M3 Screw is required where fan mount goes, I think I used a 12mm, but I don't recall. I'll try to update later.

Two parts, hopefully it is obvious how to assemble.

Use one of the 3 spacers (.5mm, 1mm, 2mm) depending on your setup. I am currently using a 2mm spacer, but your setup might require a smaller spacer.

Print instructions

Licence: Creative Commons - Attribution - Share Alike Category: 3D Printer Parts Print Settings

Printer: Prusa MK3S

Rafts: Doesn't Matter

Supports: No

Resolution: .2mm

Infill: 15% Gyroid