Qidi Led Light Diffuser X Plus 3

I made this thinking it may help with the glare when using the Qidi Camera.  Unfortunately it didn't help the glare much.  To install simply clip it onto the bar above the Leds.  Start with one end and work your way down.  Remove the same way.

Print Settings:

I found the best way to print this was vertically by painting Organic supports.  See photos.  The part is 270mm tall as that is the X Plus 3 vertical max.  Im not sure if this would work on the Max3 or Smart3 but if its the same bar to clip on you could resize it in the slicer to fit your desired length.

Best to use a higher temperature resistant filament like ABS if your printing with the chamber closed.

I did create the Qidi Ugly Camera Hat Remix that does help some of the glare:  https://www.printables.com/model/661714-qidi-ugly-camera-hat