Pyrite Snail

Be especially careful when printing.

The pyrite snail is an extremely aggressive creature.
Don’t be fooled by the lovely cute face and cute snail shell, these creatures are extremely territorial in nature and twice as fast as the average snail. They rest at night and seek refuge, in which case it is very difficult to find them, but during the day, if you see they, rather escape.

Never try to feed or caress them!

Print Settings

• Material: Gembird - Galaxy Blue Pla / Spectrum - Military Khaki Pla
• Nozzle: 0.4mm
• Layerheight: 0.1mm
• Supports: Pyrite house: Support on build plate only
• Seam position: Aligned
• Seam Paint: Enough just on the back of the body model

For Mini Settings
Printer Settings - Extruder

• Length: 1.2
• Retraction Speed: 40
• Retract amount before wipe: 0

This is necessary because I have noticed that the mini sometimes leaves rather ugly scars, not only when changing layers, but every time after retraction and travel.
I hope and the observations show that these settings have improved on this settings.

Post Process

Remove the supports that are left on it, then glue them together with super glue.