Creality K1 Air Filter Housing

This housing uses carbon air filters commonly found in Kenmore and LG refrigerators to filter the air exiting the back of the Creality K1 3D printer. Installation is a breeze utilizing two of the fan's mounting screws and provides much-needed filtration of the air.

Step 1: Open the glass door on the printer and use a hex tool to remove two of the screws from the fan.

Step 2: Hold the housing in place with the filter opening facing up and screw the housing into the case using the two screws removed in Step 1.

Step 3: Slide the filter into place from the top with the word “FRONT” facing out.

Step 4: Power on your printer and enjoy fresh air in your room.

Purchase Air Filters Here (this is not an affiliate link - I do not make any money if you buy from this link):

https://www.amazon.com/dp/B078WK2Q83

Commercial use questions? Contact me directly at [email protected]