Dino-Clip with Hole for Magnet

I remixed the Dino Clip with a hole for a 6mm Wide by 3mm Deep Magnet. I printed this with PLA+ for extra durability.

I recommend putting some epoxy or other glue of your choice in the hole and pressing the magnet it. It should be a snug fit. The bit of epoxy at the bottom will help the magnet sit flush or barely above the surface (depending on amount of epoxy used), this brings the magnet to the perfect distance to stick solidly to your fridge for easy storage. I like to keep a bunch of these stuck to the side of the fridge so I never have to go rummaging for a chip clip. :)