Roborock S5 Max - mop cloth insert with water channels

Great job! Thank you

Roborock S50 works fine with the adapter, thank you

Seams to work great for Roborock 6 Pure too

Printed on Prusa Mini

Thanks for the model! Finally got to print it in TPE.
Layer height: 0.15mm

Make it all the way to the sides please

Copying into the new defacto STL-website ;)
Nice design! Printed without any issues, 0.16mm height just to get the slanted design right. It fits the original S5 Max perfectly, used double-sided tape (tissue-tape) in a square pattern which holds up great. It definitely helps with getting the mop down a bit more and getting more even streaks. Recommended upgrade :) I also added the raised nozzles by the same creator, good combo. Have been using this for half a year now and I can still see the perfect, even streaks of water when using the mop-mode (I always set it to max). (edited)

I would prefer a version where it goes all the way to the edges and maybe would be a little thinner on the thick side. At the moment it does cover whole are of the insert, but edges are always dry :( (edited)