Apple shaped Apple Airtag Holder (Snap-Fit, key ring hole)

This is a apple logo-styled airtag holder that snaps together.

v2_improved_fit is better one to print for most end-users, doesn't require excessive amounts of force to snap together.

The snap-fit is intentionally very tight, as this can be imagined to be used with pets for example so it can't come apart on its own.
The intention is that you have to use bit of force to put it together - but once it's in, it stays in.

Make sure to position the airtag in the orientation you want to display it with.

It can be taken apart with prying tool, but the snaps might break then depending on how much force you'll have to use.
On print done on my better printer (Sidewinder X1) I have no issues taking it apart, on my second printer one (Delta Kossel) I broke some clips in process as it is bit worse with tolerances.

HINT: You can use the spatula you use to detach prints from buildplate as prying tool if your printer is bit worse with tolerances and it won't open otherwise. Don't try to use your fingernails for your own safety to avoid "happy little accidents".

HINT: if your printer isn't as good with tolerances and it feels way too tight to be 
connected with hand for the first time you can cheat with the snaps by using your foots's heel. Naturally without the airtag on. After that it'll work easily :)

Print Settings

Rafts:

No

Supports: 

No

Resolution:

200

Infill: 

20

Filament:

Fiberlogy PLA Vertigo

Category: Accessories