QIDI tech x-plus 3 door spoolholder

allows to dry a spool of filament during printing by heating in the heated chamber of the x-plus 3. It is dimensioned to print on the printer in one piece. A fairly long PTFE tube is needed to install the Bracket, i also shimmed with some paper and drilled the PTFE tube hole out with a 4mm drill. Rotate the bracket to get it in place.

I would suggest ABS/ASA or some more heat tolerant material. I used very light print settings (2 Perimeters, 10%), as i was prototypting, and as it works, it will remain like that until it breaks. 3-4 Perimeters and 30% would be better, though…

the freecad file is attached for your viewing horror. Do not use it to modify the bracket, just redraw everything and use the dimensions in the file.