E-Lab Power supply mod (slotted vents, barrel plugs)

Slight variation for the amazing case by @Stanley_97458 to fit my personal needs.

• Removed XT60 ports
• Added port for a barrel plug (input)
• Replaced 2mm front terminal ports with a barrel plug
• Added slotted ventilation holes
• Added cutouts for 8mm self adhesive rubber feet

Step file included.

Use this back panel to close up the rear side: https://www.thingiverse.com/thing:4911078

(Cut off one of the clips in case it's colliding with your step down module)

Printed with 0.1mm layer height, no supports. Front panel is facing the build plate.

• Removed XT60 ports
• Added port for a barrel plug (input)
• Replaced 2mm front terminal ports with a barrel plug
• Added slotted ventiolation holes
• Added cutouts for 8mm self adhesive rubber feet