Concerto Ukulele

So i made this Ukulele for 3D Printing. Its a Concerto Ukulele so its a little bit large. Of course it cannot be printed as a single body. That's why i have splitted it in different parts.
I would suggest to sand it before putting it together, and use a good adhesive, since this will be under a lot of stress once its tuned. You should also take that into consideration for the direction you print this, specially on the neck, head and bridge. I personally would print the bridge so the holes are facing upwards.

The pegs are threaded wit a 6mm radius, and the holes in the head with a 6.3mm radius. This should be enough for a tight fit for most printers. It will depend of course on your 3D printer. To test it I would suggest printing the Head and then sanding one Peg until it fits.

As you can see i have not printed it as I don't have any 3D printers currently available, so please, talk to me about any problems.

Here's a video that explains how to change the strings
https://youtu.be/Wi6EIJB0oSw

I really hope you find this useful